Had a successful weekend on the bus. Just wish I had more time. Camping trip in 2 weeks and I don’t think the Bus is going to be ready. May hafta venture out without her this time.
I was able to leave work a few minutes early on Friday to stop by a new found body supply shop before closing time at 5:00pm. Very nice staff was really helpful and not just sell you anything.
Was able to finish up the installation of the rear below the engine panel. It was a bear to get welded in. Not sure why, but half of my welds wouldn’t stick. I cleaned it, redrilled the holes and after 3 or 4 attempts, I was finally able to complete it. Finished wrapping the crimps and primered everything .
Also was able to seam seal the battery tray in last night. Used 3M’s Fast ‘n Firm Seam Sealer and was able to use a basic caulking gun to apply. I did clean the area thoroughly of all rust and then with prepsol prior to application. My only concern was trying to get a full tube of sealer with the gun in the small area, but somehow managed with no major setbacks. The sealer skinned over in about 20 minutes and was easy to clean up any extra that may have dripped. Went back this morning to check and it was still soft so hopefully after 24 hours it will be ready for some primer.
Regarding this posts title, I cannot stand welding while lying down. There is not enough room to use my helmet, so had to resort to my face shield, holding the light AND trying to weld at the same time. Certainly couldn’t get a full bead going, but was able to tack weld it enough to hold it securely. Hope tonight maybe to grind down the welds and apply seam sealer to underneath and give it another 24 hours before applying undercoating.
Also, BEWARE and MAKE SURE to apply this particular seam sealer in well ventilated area. I thought mine was ventilated enough with the fan going and open door, and it doesn’t appear to smell that strong, but after finishing the job, I felt like the fumes were still in my lungs for a few hours.
A few pics of the progress:
